Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Remove or disconnect the following: Negative battery cable Accessory drive belt Crankshaft pulley Water pump 6 bolts Installation is the reverse of removal. If you do get brake fluid in your eyes, flush your eyes with clean, running water for 15 minutes. Note the radio security code and disconnect the negative battery cable. Press the hub out of the wheel bearing. Before servicing the vehicle, refer to the Precautions Section. Separate the lines, discard the grommets and plug the openings to prevent contamination.
Install the intake manifold cover. Simultaneously squeeze the upper and lower radiator hoses to help push any captured air pockets out of the system. Tighten the bolts to 66 ft. Working from the sensor end to the connector, install each clip, retainer, bracket or grommet holding the sensor harness. Tighten the remaining mount fasteners as follows: A. Remove the bolt A securing the power steering hose bracket.
If it is out of the standard range, the belt must be replaced 2. Fill the radiator with engine coolant and bleed the air from the cooling system with the heater valve open. Discharge and recover the air conditioning system refrigerant. Inspect the cover washers C. Connect the negative battery cable. Coolant should be reused unless it is contaminated or is several years old.
The indicator the front wheels away from the curb. If the belt tension is not within specification, repeat the previous procedures until the proper belt tension is achieved. Start the engine and check for coolant leaks and normal operation of the cooling fans. Remove the old air cleaner air cleaner housing on the right side element. Reassemble in the reverse order of disassembly. .
Intake locknut torque is 14 ft. Left and right front mounts. . Avoid physical contact at all times, wear protective clothing and eye protection. Exploded view of the water pump mounting To install: 1.
Oil pan fastener tightening sequence-2. Tighten the mounting bolts, in a three step crisscross pattern, to the following specifications: 2001 models: 54 ft. Start the engine and check for leaks. Check the wheel alignment and adjust as necessary. Tighten the fittings to 11 ft. A spilled liquid that out and used as a table.
Lower the powertrain into position. Check and clear codes as necessary. . Right front mount 12mm nut to 43 ft. Remove or disconnect the following: Negative battery cable Air bag and steering wheel Front wheels Driver-s side dashboard lower cover and undercover Air cleaner housing Steering joint bolts Tie rod ends Steering hoses Left side flange bolts Mounting brackets 4. Accessory drive belt routing -2.
Push the release button information and a warning about how to and pull the restraint out of the seat- properly position the head restraints. Tighten the nut to 47 ft. Take careful note of the placement and routing of the harness; it must be reinstalled in the exact original position. Clean and dry the crankshaft pulley A , crankshaft B , bolt C , and washer D. Working from the sensor end to the connector, install each clip, retainer, bracket or grommet holding the sensor harness. To install: Page 36 Back to Top Fig. Tighten the bolts in sequence to 105 inch lbs.