The light tells you if there is an electrical problem. Of course, applying the brakes ends cruise control. Some noise is acceptable and audible at certain speeds, or under various driving conditions, such as a newly-paved blacktop road. In moderate to severe side collisions, even belted occupants can contact the inside of the vehicle. But you can unbuckle a safety belt, even if you are upside down.
Get it up to speed. Turn the tune knob clockwise or counterclockwise to increase or decrease the setting. Worn propeller shaft constant velocity joint. Turn the pressure cap slowly counterclockwise about one-quarter of a turn. Pull the handle with this symbol on it. You could lose control of the vehicle.
Turn the vertical aiming screw until the headlamp beam is aimed to the horizontal tape line. This system is designed to make installation of a child restraint easier. This will disengage the cruise control. It should be worn over the shoulder at all times. The air outlet duct must be replaced if damaged. This is based on engine revolutions and engine temperature, and not on mileage.
If you do not, your brakes may no longer work properly. It should be worn over the shoulder at all times. See Defensive Driving on page 230. If you have to stop or turn quickly, or if there is a crash, they will keep going. Refer to Lubricant Replacement - Rear Drive Axle. Drive at the same speed most of the other drivers are driving. To adjust the vertical aim, do the following: 1.
Some electrical equipment can damage your vehicle and the damage would not be covered by your warranty. Find your 2007 Saturn Vue repair manual right now at Chilton. Always turn off your radio and other accessories when jump starting your vehicle. Pull up on the seatback to be sure it is locked. Airbags supplement the protection provided by safety belts. Wait for 10 seconds and restart your vehicle.
Gear set whine noise within axle assembly created by incorrect gear backlash A whine type of noise will increase of decrease relative to vehicle speed. Lift the recliner lever, located on the outboard side of the seat, up fully and fold the seatback forward until it disengages. They will be ready and willing to help if you need it. Once the disc is ejected, Remove Disc displays. To avoid this, everyone in the vehicle should get out as soon as it is safe to do so.
Notice: Overloading your vehicle may cause damage. If a more thorough cleaning is necessary, a clean soft cloth dampened with a mild soap solution can be used to gently remove dust and dirt. When you want to leave the freeway, move to the proper lane well in advance. Clean the area around the fluid fill plug. Intended Outboard Sidewall: The side of an asymmetrical tire, that must always face outward when mounted on a vehicle. Always turn off electrical equipment when not in use and do not plug in equipment that exceeds the maximum 20 ampere rating. Notice: Do not store the headphones in heat or direct sunlight.
The sudden movement could startle and confuse you, or make you push a pedal when you do not want to. Try not to break the fragile traction. Wheel Alignment and Tire Balance. A worn axle shaft constant velocity joint may create a clicking, grinding, or snapping type of noise. Bearing noise within axle assembly A grinding roar type of noise will increase or decrease relative to the vehicle speed. An older child should wear a lap-shoulder belt and get the additional restraint a shoulder belt can provide. The repairs would not be covered by your warranty.
A loose dust shield may contact the propeller shaft assembly and create a scraping or grinding type of noise. You never know if you will be in a crash. The belt forces would be there, not at your pelvic bones. The system checks the airbag electrical system for malfunctions. Close and lock the door.
The load index can range from 1 to 279. Don't waste time calling around to your local bookstores or waiting for a repair manual to arrive by mail. Continue cleaning, using a clean area of the cloth each time it becomes soiled. . See Loading Your Vehicle on page 279. Remove the propeller shaft underbody guard loop bolts.